X2
From Robin
m |
m |
||
Line 11: | Line 11: | ||
see the matlab script testRobot.m, below, for usage example | see the matlab script testRobot.m, below, for usage example | ||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
robot = openRobot('COM6','COM4','COM5'); %creates a robot struct, with matlab objects for each joint | robot = openRobot('COM6','COM4','COM5'); %creates a robot struct, with matlab objects for each joint | ||
getStatus(robot); %get the status of the robot | getStatus(robot); %get the status of the robot | ||
- | motorToggle(robot); | + | motorToggle(robot); %toggle motor on |
setRobotAngles(robot,0,0,15); %set the angles of joint 1, 2, and 3 in degrees | setRobotAngles(robot,0,0,15); %set the angles of joint 1, 2, and 3 in degrees | ||
- | pause(10); | + | pause(10); %pause the script, waiting for the robot to perform the task |
- | motorToggle(robot); | + | motorToggle(robot); %toggle motor off |
pause(1); %small pause | pause(1); %small pause | ||
closeRobot(robot); %close the connection to the com ports | closeRobot(robot); %close the connection to the com ports |
Current revision as of 00:20, 2 February 2012
The X2 robot has been developed from parts printed with our 3D printer Connex500.
Usage
In the ROBIN robotics lab, the desktop computer next to the X2 robot is set up to communicate with the robot.
Matlab
Matlab functions to communicate with the robot have been developed. These are included with the compulsory exercises which the robot will be used for.
see the matlab script testRobot.m, below, for usage example
robot = openRobot('COM6','COM4','COM5'); %creates a robot struct, with matlab objects for each joint getStatus(robot); %get the status of the robot motorToggle(robot); %toggle motor on setRobotAngles(robot,0,0,15); %set the angles of joint 1, 2, and 3 in degrees pause(10); %pause the script, waiting for the robot to perform the task motorToggle(robot); %toggle motor off pause(1); %small pause closeRobot(robot); %close the connection to the com ports
The robot will need some time to move to a new position, so remember to include pauses in your matlab code.
IMPORTANT: The robot must be in the (0 0 0) joint configuration before starting
Arduino controller
The arduino software is located at C:\sonen\arduino Open the file C:\arduino_sketch\x2.pde to control the robot. Set baud rate to 115200
The commented lines in the top of the x2.pde file show the available commands. E.g. "?" will give the status of the robot.
joint angle 1440 is 0 degrees, joint angle 0 is -180 degrees, joint angle 2880 is 180 degrees,
The joints are located at Com4-Com6
Default pid-parameters, that seem to be working fine: p = 14, i=10, s=2
The "Controller" folder in the "libraries" folder, contains the controller project.
More info on the arduino part can be found here.