Printlog
From Robin
(Difference between revisions)
(→The 3D-printing log) |
(→The 3D-printing log) |
||
| Line 3: | Line 3: | ||
What we would like to have covered is at least, but not limited to | What we would like to have covered is at least, but not limited to | ||
| - | + | '''The name of the design or project''' | |
| - | + | Your name and position | |
| - | + | A picture of the CAD model | |
| - | + | A short description of the purpose of the design | |
| - | + | One or more pictures of the design, preferably in use. | |
| - | + | Interesting discoveries or aspects with this model | |
Feel free to add links to project websites or your own homepage. | Feel free to add links to project websites or your own homepage. | ||
Revision as of 12:00, 3 September 2010
The 3D-printing log
In this page we would like all that has made a 3D-print to add a few lines about their 3D-printing project.
What we would like to have covered is at least, but not limited to
The name of the design or project Your name and position A picture of the CAD model A short description of the purpose of the design One or more pictures of the design, preferably in use. Interesting discoveries or aspects with this model
Feel free to add links to project websites or your own homepage.
Please insert your entry above the entries that have already been made.
Log entries
Ball joint material test
By Yngve Hafting
Fil:Mattest1.jpg Fil:Mattest2.jpg
The purpose of this project is to test some of the material properties for both Tango+ and Fullcure720
Fil:Mattest3.jpg Fil:Mattest4.jpg
Discoveries
- The inner blob was made in Tango+ to push the balljoint back in position. Being attached to the cup and free from the balljoint, it did push back the joint some, but not nearly 100%. After some manipulation, the inner blob in one of the joints got detached from the cup. To have better spring effects the ball must be attached to both the balljoint and the cup, if it will survive the physical manipulation.
- 0.25mm works for clearance
