Dynamixel
From Robin
(Difference between revisions)
Line 6: | Line 6: | ||
Pinout: | Pinout: | ||
[[Image:u2d pinfigure.jpg]] | [[Image:u2d pinfigure.jpg]] | ||
+ | |||
+ | |||
+ | == Information == | ||
+ | |||
+ | The three dynamixel series in use are AX-12A, AX-18A and MX series. This guide for "getting started" is based on these three series. Refer to the image on the side for difference in the dynamixel series. | ||
+ | |||
+ | == Getting Started == | ||
+ | |||
+ | === Components === | ||
+ | |||
+ | ==== Hardware ==== | ||
+ | |||
+ | * PSU - Dynamixel power supply | ||
+ | * USB2Dynamixel converter | ||
+ | * Dynamixel AX/MX series | ||
+ | * Connecter – Power hub | ||
+ | |||
+ | ==== Software ==== | ||
+ | |||
+ | * Dynamixel Wizard [https://emanual.robotis.com/docs/en/software/rplus1/dynamixel_wizard/] | ||
+ | * RoboPlus Manager 2.0 [https://emanual.robotis.com/docs/en/software/rplus2/manager/] | ||
+ | |||
+ | === Update Firmware === | ||
+ | Firmware controls the dynamixel and is installed on the dynamixel. It can be updated through the following steps: | ||
+ | * Open "RoboPlus" to launch “Dynamixel Wizard" or directly open “Dynamixel Wizard”. | ||
+ | * Select the right port and open it. | ||
+ | ** For windows the ports would be COM*, for LInux it should be in the form /dev/ ttyUSB* | ||
+ | ** <Start search> and on the side you should be able to see the actuator/dynamixel connected. Clicking on it would open up its description. | ||
+ | ** Select <Dynamixel firmware update> [[Image:Dynamixel firmware update.png|thumb|30px|Dynamixel firmware update]] and follow the steps mentioned by the wizard. For more information refer to:[ https://emanual.robotis.com/docs/en/software/rplus1/dynamixel_wizard/#firmware-update] |
Revision as of 15:07, 25 April 2023
See our getting started template on https://github.uio.no/robin-engineer/dynamixel
Contents |
Information
The three dynamixel series in use are AX-12A, AX-18A and MX series. This guide for "getting started" is based on these three series. Refer to the image on the side for difference in the dynamixel series.
Getting Started
Components
Hardware
- PSU - Dynamixel power supply
- USB2Dynamixel converter
- Dynamixel AX/MX series
- Connecter – Power hub
Software
Update Firmware
Firmware controls the dynamixel and is installed on the dynamixel. It can be updated through the following steps:
- Open "RoboPlus" to launch “Dynamixel Wizard" or directly open “Dynamixel Wizard”.
- Select the right port and open it.
- For windows the ports would be COM*, for LInux it should be in the form /dev/ ttyUSB*
- <Start search> and on the side you should be able to see the actuator/dynamixel connected. Clicking on it would open up its description.
- Select <Dynamixel firmware update> and follow the steps mentioned by the wizard. For more information refer to:[ https://emanual.robotis.com/docs/en/software/rplus1/dynamixel_wizard/#firmware-update]