Rapid Music Instrument Prototyping

From Robin

Revision as of 15:01, 6 October 2008 (view source) Alexanje (Talk | contribs) (→Sensors) ← Older edit		Revision as of 15:21, 6 October 2008 (view source) Alexanje (Talk | contribs) (→Sensor interfaces) Newer edit →
Line 10:		Line 10:
	== Sensor interfaces ==		== Sensor interfaces ==
-	* [http://www.create.ucsb.edu/~dano/CUI/ CUI]	+	* [http://www.create.ucsb.edu/~dano/CUI/ CUI]:
	* [http://arduino.cc/ Arduino]		* [http://arduino.cc/ Arduino]
		+	* [http://www.phidgets.com/ Phidgets]: commercial USB-based sensor interface with standardized connectors.
	== Communication ==		== Communication ==

---

Revision as of 15:21, 6 October 2008

On this page we are documenting everything that is needed to create rapid prototypes of a complete electronic music instrument/controller.

Contents 1 3D printing 2 Sensor interfaces 3 Communication 4 Sensors 5 Speakers and amplifiers 6 Actuators

3D printing

• 3D-printer
• Creating a 3D print
• Solidworks

Sensor interfaces

• CUI:
• Arduino
• Phidgets: commercial USB-based sensor interface with standardized connectors.

Communication

• OSC: Open Sound Control for communicating between devices
• uOSC: Open Sound Control Reference Platform for Embedded Devices
• SLIP: Serial Line Internet Protocol

Sensors

Sensors used for finger control:

• Interlink MicroNav 360: XY + pressure sensor
• Interlink FSRs

Acceleration:

• SparkFun

Speakers and amplifiers

Suggestion by Dan Trueman:

• Charlize: a Tripath Class-T amp based on the Tripath TA2020
• Sonic Impact 5065: Gen 2 T-Amp with Power Supply

Actuators

• Motors