Designing 3D-models
From Robin
(Difference between revisions)
(→General advice) |
|||
| Line 2: | Line 2: | ||
== General advice== | == General advice== | ||
| + | * STL -files should be designed using millimetres rather than inches. | ||
* Make sure you have ways to remove unwanted support or unused material. | * Make sure you have ways to remove unwanted support or unused material. | ||
** The use of support and the presence of excess material vary between different printing technologies. | ** The use of support and the presence of excess material vary between different printing technologies. | ||
Current revision as of 12:18, 26 August 2010
The intention for this page is to contain advice or pointers to advice on making 3D-models for printing.
General advice
- STL -files should be designed using millimetres rather than inches.
- Make sure you have ways to remove unwanted support or unused material.
- The use of support and the presence of excess material vary between different printing technologies.
- Tolerances should be set according to the printing technology.
- 0.2mm is minimum tolerance for our FDM printer
